BubbleMill Instructions

Setup

1. Insert legs into main body of bubble machine (press fit).
2. Place Bubble-Mill our of reach of children (at least 60 inches from floor).
3. Fill pan with bubble solution (not included). For best results, use the bubble solutions typically found at toy or party supply stores.
4. Install Bubble wheel as shown on label (the short side of the shaft goes closest to the fan).
5. Place top half of bubble machine onto main housing (see label).
6. Plug bubble machine into a grounded outlet.

Clean Up

1. Unplug BubbleMill.
2. Remove bubble wheel and rinse with water.
3. Empty remaining bubble solution and rise pan with water.
4. Clean top with damp cloth (exterior only).

Caution

• This machine is for outdoor use only
• Adult supervision is required
• Keep electrical components away from moisture at all times.
• This product produces a large amount of bubbles which may make surrounding surfaces slick. Take care that play areas are cleaned after and during hevy use.
• To avoid slipping hazard, do not operate near smooth or wet surfaces
• Never leave unattended to avoid injury
• Do not use if possibility of rain exists

Troubleshooting

The most common issue is that the bubble solution may be too thick. Simply water it down by a third for better performance.

Bubbles are affected by extremely high temperatures and may not last long at temperatures above 95'F. This is simply a characteristic of liquid bubbles.